Riverstone Networks WICT1-12 Dokumentacja Pobierz pdf (Strona 47)

Riverstone Networks RS 32000 Switch Router Getting Started Guide 2-27

Introduction Hardware Overview

Table 2-15 GBIC line card LEDs

LED Description

Online When lit, this green LED indicates that the line card is online and is ready to receive, process,

and send packets if configured to do so.

Offline When lit, this amber LED indicates that the line card is offline (powered off) and is ready for

hot swap.

The Offline LED also is lit briefly during a reboot or reset of the RS and goes out as soon as

the Control Module discovers and properly initializes the line card.

Per-GBIC RX Green – indicates when the GBIC’s transceiver receives packets

Amber – indicates when the GBIC’s transceiver receives flow-control packets

Per-GBIC TX Green – indicates when the GBIC’s transceiver transmits packets

Amber – indicates when the GBIC’s transceiver transmits flow-control packets

Per-GBIC AN Green – indicates that the port hardware has auto negotiated the operating mode of the link

between full-duplex and half-duplex.

Orange (intermittent) – indicates that auto negotiation is in process.

Orange (solid) – indicates a problem with auto negotiation configuration.

Red – indicates an auto negotiation failure. This fault may occur if the link partner does not

support full duplex.

Off – indicates that auto negotiation has been disabled or the link is down.

Per-GBIC LINK Green – indicates that the port hardware detects a cable plugged into the port and a good link

is established.

Red (intermittent) – indicates that port hardware received an error during operation.

Red (solid) – indicates that the port hardware detects a cable plugged into the port, however, a

bad link is established.

Off – indicates that no link from the port exists.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 110 111

Brak uwag

Riverstone Networks WICT1-12 Dokumentacja Strona 47