Riverstone Networks WICT1-12 Dokumentacja Pobierz pdf (Strona 98)

5-6 Riverstone Networks RS 32000 Switch Router Getting Started Guide

Loading Software from the Network Managing Software

5.3 LOADING SOFTWARE FROM THE NETWORK

Typically, the RS 32000 loads its operating software from the PC flash card inserted in the Control Module.

Alternately, the RS 32000 can be configured to ignore its PC flash image and obtain its software from a network server.

The RS 32000 can obtain its image software from either a TFTP or BootP/TFTP server.

Note If you are loading software from the network and are using redundant Control

Modules, see Section 4.9.3, "Things to Remember when Using Redundant Control

Modules" for information regarding interface addresses.

5.3.1 Loading Image Software from a TFTP Server

Perform the following procedure to configure the RS 32000 to load its image software from a TFTP server:

1. Copy the image software onto a TFTP server that the RS 32000 can access.

2. Reboot the RS 32000 and enter Boot mode by pressing the “Esc” key to interrupt the normal boot

process.

3. At the Boot prompt, enter the set command to view the current bootPROM variable values.

Here is an example:

4. Notice in the example above that netaddr, netmask, and gateway have the value 0.0.0.0, and

that

bootsource = /pc-flash/boot/ros80.

5. From the Boot prompt, use the set command to set the following:

• IP address of the RS 32000 – (netaddr)

re-boot> set

...tty1 = 9600

bootdiagmode = off [off on quick mfg-test]

diag_log =

mfg_loop_by = time [time count]

mfg_loop_max = 86400

bootdelay = 2

promsetaddrs = 1

flow_control = on [off on]

bootptimeout = 5

netaddr = 0.0.0.0

autoboot = boot

netmask = 0,0,0,0

gateway = 0.0.0.0

bootsource = /pc-flash/boot/ros80

bootaddr = 0.0.0.0

ethaddr = 00:00:1d:12:34:56

(ethaddr is base MAC addr, add one for actual CPU MAC address)

sysid = -1

rs-boot>

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 110 111

Brak uwag

Riverstone Networks WICT1-12 Dokumentacja Strona 98